Directions for installing RXV Fender Flares 1) Disable Vehicle: 1.1 Turn the key switch OFF and remove key, place the forward/reverse handle in the Neutral position, engage car brake, and chock tires. 2) Kit Includes: 2.1 Two front and rear fender flares 2.2 Christmas tree fasteners 3) Tools required 3.1 Power Drill w/ 15/64” drill bit **size of drill bit may vary** 3.2 Black marker to mark holes 4) Installation 4.1 Drill 15/64 ” holes in fender flares as required 4.2 Visually line up front and rear flares around wheel openings and mark hole locations at each end of flare. 4.3 Drill holes in body at each end of flare and fasten as required 4.4 Drill and fasten remaining mounting points (in the center of flare) As required pulling flare tight to seal to body panel. **Instructions may vary depending on model of cart.**